Main Page Sitemap

Mita copier service manual pdf


mita copier service manual pdf

I've tried it so far only on an old 1010 drum, with mixed results so far (worked great at first, but now copies are getting dirty - don't know if it's the wax acting up, inetinfo exe faulting module aspnet isapi dll the drum going despite the wax, or other problems.
Toner, because it's a very fine powder, is (a) carcinogenic, and (b) explosive.
What would cause the lamp to overheat?This is known to damage the DC controller board (at least a 60 part, exchange - over 300 purchase!Standing in front of the printer with the top cover up it will be in the far left lower corner.If you remove the reg.If that's what's happening, usually replacing collage maker 3.80 keygen just the wiper blade will cure.Has a set of articles on specific laser printer print engine maintenance, repair, parts interchangeability, etc.We even cover areas of some (scratched) after-market drums and exposed them to sunlight to see how it effected them.I see no obvious gear wear or broken teeth.So you can pick out the black rubber roller too Clean everything with isopropyl alcohol Reassembly everything in reverse order.
Look at it now, before removing the reg assy, to see how it's supposed to look.
Inspect them as above, and try a drop of oil.
My cost was 150.00.
Reseat connectors J002 on the DC Controller and J601 on the Laser Drive PCA.
I suspect that it was probably the HV reset line that was the problem.If an image of your test document exists on the drum, then the main corona unit is working at least.It can't be *that* harmful, as some photocopiers take 'loose' toner, and some printers have separate toner/drum/waste toner units.This turns on Q210 (2SC1815) which charges C211 (100 uF) via R749 (330 ohms).Oh yes, how to dismantle the scanner to replace the chip.It works well except all the copies have a grey tinge to them, even when the auto-exposure control is set to light.The other pin of J103 (and thus the other side of the fuser lamp) is returned to the neutral side of the mains via the triac Q101.However, it sounds like a nice time for known good spares or another known good LX engine to borrow known good assemblies from.Most navigon 8110 update 8310 full version likely if there is no Grit, and the Black area is Grey, then I would suggest changing the Developer (or you might even have a Developer Drive Problem gears and stuff).The "which edge is the binding edge" choices are always disabled, but turning it on at the printer works (unselectively).They also sell parts and supplies at a fairly reasonable rate.


Sitemap